Using PCB-Gcode in Fusion 360?

[TSJim]

I'm trying to use PCB-Gcode in Fusion 360.

I have installed PCB-Gcode 3.6.2.4 it into the same directory as the rest of the ULPs.

The good news is that the "pcb-gcode-setup.ulp" works fine.

However, when I try to run the "pcb-gcode.ulp" program, I get the following error message in Fusion 360:

/Users/jim/Library/.../examples/ulps/examples/pcb-gcode.ulp(1387):

polygons loop is depreciated.  Use polyPours polyShapes polyCutouts instead.

Is there a way to fix this?

[hilsonp]

An old post I made explaining my trial a few years ago might give you some ideas.

https://groups.io/g/pcbgcode/topic/75874702#8182

I should give it another trial. Fusion360 fixed something, maybe.

[JohnAtl]

Hi Jim, You don’t have to run pcb-gcode directly, just set your options in pcb-gcode-setup, then click the Make my board (forget the exact wording) button. Give that a shot and see how it works.

…

Sent from my iPhone

On Jul 25, 2022, at 3:10 PM, TSJim ***@***.***> wrote:  I'm trying to use PCB-Gcode in Fusion 360. I have installed PCB-Gcode 3.6.2.4 it into the same directory as the rest of the ULPs. The good news is that the "pcb-gcode-setup.ulp" works fine. However, when I try to run the "pcb-gcode.ulp" program, I get the following error message: **/Users/jim/Library/.../examples/ulps/examples/pcb-gcode.ulp(1387): polygons loop is depreciated. Use polyPours polyShapes polyCutouts instead.** Is there a way to fix this? — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you are subscribed to this thread.